Water substitution on iron centers: from 0D to 1D sandwich type polyoxotungstates

Four novel polyoxotungstates have been synthesized by reaction of the sandwich type compound [Fe (III) 4(H 2O) 10(B-beta-SbW 9O 33) 2] (6-) (noted Fe 4(H 2O) 10Sb 2W 18) with ethylenediamine (en) and/or oxalate (ox) ligands under various conditions. The one-dimensional (1D) compound [enH 2] 3[Fe (III) 4(H 2O) 8(SbW 9O 33) 2].20H 2O ( 1) is isolated at 130 degrees C and results from the elimination of two water molecules and the condensation of the polyoxotungstate precursor. The reaction of Fe 4(H 2O) 10Sb 2W 18 with oxalate ligands affords the molecular complex Na 14[Fe (III) 4(ox) 4(H 2O) 2(SbW 9O 33) 2].60H 2O ( 2) where two organic ligands substitute four water molecules, while the same reaction in the presence of en molecules at 130 degrees C leads to the formation of the functionalized 1D chain [enH 2] 7[Fe (III) 4(ox) 4(SbW 9O 33) 2].14H 2O ( 3) with protonated ethylenediamine counterions. Finally, at 160 degrees C a rearrangement of the Fe 4(H 2O) 10Sb 2W 18 polyoxotungstate is observed, and the sandwich type compound [enH 2] 5[Fe (II) 2Fe (II) 2(enH) 2(Fe (III)W 9O 34) 2].24H 2O ( 4) crystallizes. In 4, the heteroelement is a Fe (III) ion, and the water molecules on the two outer Fe (II) centers are bound to pendant monoprotonated en ligands. The four compounds have been characterized by IR spectroscopy, thermogravimetric analysis, and single crystal X-ray diffraction. A detailed study of the magnetic properties of the mixed-valent hexanuclear iron complex in 4 shows evidence of an S = 5 ground-state because of spin frustration effects. A quantification of the electronic parameters characterizing the ground state ( D = +1.12 cm (-1), E/ D = 0.15) confirms that polyoxotungstate ligands induce large magnetic anisotropy.     

Fine characterization of the ethylene and ethane sorption in poly(amide 12-block-tetramethylenoxide) copolymer/AgBF4 membranes

Ethylene/ethane sorption characteristics were determined for dry Pebax™ (poly(amide 12-block-tetramethylenoxide) copolymer)/AgBF₄ membranes by using an electronic microbalance. The membranes containing 0.7 and 22 wt.% AgBF₄ showed a dual-mode sorption isotherm. The ethane isotherms for all the membranes were of the Henry-type, which is the normal sorption for gases in rubbery polymers. The abnormal presence of Langmuir sorption sites only for ethylene in the rubbery copolymer, never reported sofar, is attributed to the silver-based specific complexation sites. The silver salt which dissolved in limited amounts in the rubbery copolymer had a much smaller Langmuir sorption capacity than the salt that crystallized in the copolymer. The sorption kinetics indicate that the crystallized salt did adsorb slowly ethylene according to a zeroth-order kinetics, but not ethane. The gas uptake kinetics resulting from a step of the pressure surrounding the copolymer exhibited one stage for ethane but two stages for ethylene. For the latter, there was first a fast Fickian sorption stage, then a drift of the zeroth-order sorption of ethylene on salt crystals, which contributes for a large part to the total uptake. The zeroth-order sorption suggests that the sorbed ethylene amount in the second-stage is independent of the crystal-surface coverage. The value of the Fickian diffusion coefficient calculated by fitting the kinetics with a solution of the second Fick’s law was 5 × 10⁻¹² m²/s for both ethylene (the first stage) and ethane, and is typical for small organic compounds in a rubbery material.     

Detailed analysis of the essential oil from Cistus albidus L. by combination of GC/RI, GC/MS and 13C-NMR spectroscopy

The composition of the essential oil of Cistus albidus (L.) obtained from plants growing wild in Provence (France) has been investigated using GC-RI (RI = retention indices), GC/MS and (13)C-NMR. Eighty-eight components were reported accounting for 81.8% of the essential oil. This essential oil was characterized by a high content of sesquiterpenes with alpha-zingiberene (12.8%), alpha-curcumene (7.7%), (E)-beta-caryophyllene (5.9%), alpha-cadinol (5.4%), alpha-bisabolol (4.1%), caryophyllene oxide (3.8%), allo-aromadendrene (3.4%), delta-cadinene (3.4%), and germacrene D (3.1%) being the main components.     

Embedded silver ions-containing liposomes in polyelectrolyte multilayers: cargos films for antibacterial agents

A new antibacterial coating made of poly(L-lysine)/hyaluronic acid (PLL/HA) multilayer films and liposome aggregates loaded with silver ions was designed. Liposomes filled with an AgNO 3 solution were first aggregated by the addition of PLL in solution. The obtained micrometer-sized aggregates were then deposited on a PLL/HA multilayer film, playing the role of a spacer with the support. Finally, HA/PLL/HA capping layers were deposited on top of the architecture to form a composite AgNO 3 coating. Release of encapsulated AgNO 3 from this composite coating was followed and triggered upon temperature increase over the transition temperature of vesicles, found to be equal to 34 degrees C. After determination of the minimal inhibitory concentration (MIC) of AgNO 3 in solution, the antibacterial activity of the AgNO 3 coating was investigated against Escherichia coli. A 4-log reduction in the number of viable E. coli cells was observed after contact for 120 min with a 120 ng/cm (2) AgNO 3 coating. In comparison, no bactericidal activity was found for PLL/HA films previously dipped in an AgNO 3 solution and for PLL/HA films with liposome aggregates containing no AgNO 3 solution. The strong bactericidal effect could be linked to the diffusion of silver ions out of the AgNO 3 coating, leading to an important bactericidal concentration close to the membrane of the bacteria. A simple method to prepare antibacterial coatings loaded with a high and controlled amount of AgNO 3 is therefore proposed. This procedure is far superior to that soaking AgNO 3 or Ag nanoparticles into a coating. In principle, other small bactericidal chemicals like antibiotics could be encapsulated by this method. This study opens a new route to modify surfaces with small solutes that are not permeating phospholipid membranes below the phase transition temperature.     

Fragmentation sous Impact Electronique du Phényl-2 Oxétanne

The mass spectral fragmentation processes of 2-phenyloxetane have been studied by means of isotopic labelling. The origin of the benzoyl ion, which is the base peak, is discused     

Galactose oxidase models: solution chemistry, and phenoxyl radical generation mediated by the copper status

Galactose oxidase (GO) is an enzyme that catalyzes two-electron oxidations. Its active site contains a copper atom coordinated to a tyrosyl radical, the biogenesis of which requires copper and dioxygen. We have recently studied the properties of electrochemically generated mononuclear Cu(II)-phenoxyl radical systems as model compounds of GO. We present here the solution chemistry of these ligands under various copper and dioxygen statuses: N(3)O ligands first chelate Cu(II), leading, in the presence of base, to [Cu(II)(ligand)(CH(3)CN)](+) complexes (ortho-tert-butylated ligands) or [(Cu(II))(2)(ligand)(2)](2+) complexes (ortho-methoxylated ligands). Excess copper(II) then oxidizes the complex to the corresponding mononuclear Cu(II)-phenoxyl radical species. N(2)O(2) tripodal ligands, in the presence of copper(II), afford directly a copper(II)-phenoxyl radical species. Addition of more than two molar equivalents of copper(II) affords a Cu(II)-bis(phenoxyl) diradical species. The donor set of the ligand directs the reaction towards comproportionation for ligands possessing an N(3)O donor set, while disproportionation is observed for ligands possessing an N(2)O(2) donor set. These results are discussed in the light of recent results concerning the self-processing of GO. A path involving copper(II) disproportionation is proposed for oxidation of the cross-linked tyrosinate of GO, supporting the fact that both copper(I) and copper(II) activate the enzyme.     

FLUORESCENCE PROPERTIES OF PORPHYRIN-GLOBIN FROM HUMAN HEMOGLOBIN

Fluorescence excitation and emission spectra, decays, and quantum yields are reported for the porphyrin-globin of hemoglobin (Hb^desFe) in aqueous solution of pH 8, at 4°C. A very weak fluorescence was observed in the UV (maximum at 334 nm), due to tryptophan and tyrosine residues, in addition to the strong porphyrin emission in the visible (maxima at 624 and 692 nm) reported previously. The absorption and fluorescence properties of the porphyrins of Hb^desFe were compared to those for free porphyrin in organic solvents and in aqueous solution. The close similarity of the fluorescence decays and quantum yields in Hb^desFe and in solution indicate the absence of stronger, specific porphyrin-protein interactions; however, slight spectral shifts point to the existence of water molecules in the Hb^desFe porphyrin environment. The fluorescence study also demonstrates the existence of efficient Trp-porphyrin energy transfer of Förster type. The extent of transfer is in satisfactory agreement with the value expected from crystallographic data for hemoglobin. The results are discussed and compared to previous fluorescence studies of hemoglobin and apohemoglobin. An improved method for the preparation of Hb^desFe is reported.     

A ratiometric probe for the selective time-gated luminescence detection of potassium in water

A europium probe for the ratiometric detection of potassium in water is presented. This probe demonstrates high sensitivity, with an affinity for K(+) in the mM range, and high selectivity for K(+) over Na(+), Ca(2+), Mg(2+) and Li(+). The long luminescence lifetime of the probe and its large Stokes shift further enable accurate determination of the concentration of K(+) in complex aqueous media.     

Efficient and fast Heck vinylation of 2-bromo-6-methyl pyridines with methylacrylate. Application to the synthesis of 6-methyl cyclopenta[b]pyridinone

Heck vinylation of 2-bromo-6-methyl-3-substituted pyridines using η³-allylpalladium chloride dimer/P(o-Tol)₃ complex/toluene and dimethylacetamide (DMA) as co-solvent with methyl acrylate is reported. Electronic and steric effects were investigated engaging diversely 2-bromo-3,6-disubstituted pyridines. As application, a new synthesis of the 6-methyl cyclopenta[b]pyridinone building-block connecting Heck vinylation, alkene reduction and Dieckmann condensation is described.     

1-Protected 5-amido 1,2,3-triazoles via ruthenium-catalyzed [3+2] cycloaddition of azides and ynamides

Ynamides react with various azides in the ruthenium-catalyzed Huisgen [3+2] cycloaddition reaction. This ruthenium-catalyzed azide-ynamide cycloaddition reaction yields 1-protected 5-amido 1,2,3-triazoles.